Chevy C10 Truck Forums banner

1 - 16 of 16 Posts

·
Registered
Joined
·
6,754 Posts
Discussion Starter · #1 ·
My 93 Gmc is my daily driver. I bought it new in 92. drove it to and from work for 2 years. Then moved to MI. where it became my construction work truck. then in 06 it became my daily driver again. The rockers and cab corners were showing some rust. Actualy about 90% gone. Anyway today I started the replacement of them. I started at 9 AM this morning and the passenger side is done except for paint..While I'mat it I am replacing the seats my side is a little soft (over 250K ) Thats a lot of looking out the windshield..Pictures to follow.
 

·
Registered
Joined
·
6,754 Posts
Discussion Starter · #4 ·
both rockers and cab corners done..New carpet, and newer seats. When it hits 300K I'll be comfortible. I think I'll spend tomorrow cleaning it.
 

Attachments

·
Registered
Joined
·
183 Posts
Great job Charlie! Someday I'll get back to working on my truck!

Dave
 

·
Registered
Joined
·
6,754 Posts
Discussion Starter · #7 ·
I painted the rockers and cab corners. I did not blend them as it will be getting a complete job later. There are a few dents in the bed that need attention from it being a construction truck. I figure I wait till its all done.
 

·
Premium Member
Joined
·
448 Posts
I like the dual quad setup I had a dual quad on my last engine, Tried to use a progressive linkage but ended up using a straight linkage instead.

otis :)
 

·
Registered
Joined
·
6,754 Posts
Discussion Starter · #15 ·
Seats are from 99 tahoe. When I bought them I didn't know they were electric. great suprise. I haven't taken pictures lately as the truck is a bit dirty since the repairs.
 

Attachments

1 - 16 of 16 Posts
Top