C10Trucks.com - View Single Post - Some Bead Roll Work
View Single Post
  #2  
Old 08-11-2013, 11:24 PM
ProMetalShop's Avatar
ProMetalShop ProMetalShop is offline
Administrator & Sheet Metal Junkie
 
Join Date: Nov 2012
Location: Danville Pa.
Posts: 1,128
Default

last week I welded a flange on the tunnel.



I cleaned the outside edge as well as the inside. As you can see the heat drew the edge a little hard in one area, but I should be able to shrink the outer edge the will stretch the inner edge. It actually looks a lot worse than it is.



Here it's fit up.



Should get more done next week.
__________________
Thanks Steve
https://www.facebook.com/Prometalshop?ref=hl
http://prometalshop.com/
Hot Rod Sheet Metal Fabrication and Shaping Shop.
http://i5.photobucket.com/albums/y17...ps949483d5.jpg
Reply With Quote
8