C10Trucks.com - View Single Post - Crank pulley
Thread: Crank pulley
View Single Post
Old 11-26-2018, 01:05 PM
nitro450exp nitro450exp is offline
Junior Member
Join Date: Sep 2018
Location: MI
Posts: 10
Default Crank pulley

Hello Crew.

Worked on many engines but relatively new to SBC.
Stripping down a 1965 SBC, the crank pulley is kind of odd.
It is just 2 plates riveted together with shoulder rivets about 1/2" apart.
There is no rubber element to it, it seems to have very little mass.
Also it is press fit and the crank is not tapped.
It does look like there is something in the hole in the crank, almost like a bushing.

I assume bear puller to remove it and BFH to put it back on.

Any advice welcome.

Reply With Quote