Chevy C10 Truck Forums banner

Crossmember/ Radiator Mount Combo

16K views 12 replies 5 participants last post by  ProMetalShop 
#1 ·
Had to make a front crossmember and a rad mount, so I combined the two....




















 
See less See more
10
#9 ·
Steve that is way cool, Just way talented...!
 
#13 ·
Hi Mark, yes, it punches and flairs all in one shot. You can remove the flair die and just punch the hole also. They will punch up to .063 aluminum, and 16 gauge mild steel, or 18 gauge stainless. You don't need the press to use them. They can be punch/pressed by punching a threw hole, and the mounting the punch with there nut , bolt , and bearing , and the just use a ratchet. :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top